The variable VOlume TURBIne finally within your grasp
Technologies :
- basic principle
- working clearances
and arithmetic roughness
- optimised principle
Stop control:
- hydraulic version
- electric version
3 - Technologies
3.5 - Stop control by electric motors
 Figure 3.6 - Stops controlled by electric motors |
Figure 3.6 shows another example. Here, each tilting stop is controlled by two electric motors (20 and 23) controlling an endless screw (22) activating an integral part (21) of each tilting stop, in order to limit the number of friction points. The stop shown in this figure is in the retracted position to allow the blade to pass from oneside to the other. |
******
| | |||||||||||
|
|
|
|
|
|
|
|
 |
Governing language : The source language for the documents presented on this site is French. Consequently only the French language shall prevail. |  |